Front Seat Belt Kit T2 Bay 1967–1979 T2 Split 1950–1967 & Brazilian Bay

I replace the non retractile original one, and fix perfect in place. Thank you Just Kampers, good product, good value, good delivery, again and again from you.

Deliverd bang on 9:18 am, just as JK had texted me they would. Fitted and working by 1:35pm. All the spacers are included, instructions are clear and concise and this made it an easy fit to both the passenger and driver side seats. A definite upgrade on the original 1976 seat belts. Would go as far as to say I wish I had done this upgrade sooner. And I got the 10% discount for having my insurance with JK. Thank you Just Kampers, great parts yet again.

The stalk is a bit long at 45cms for a non walk through model. If you have a fixed bulkhead vehicle (crew cab etc) then Securon make a version with a 30cm stalk. This puts the female seatbelt receiver in a better place. Good quality and multiple brackets to aid fitment.

Wanted to replace the existing belt as it wasn't retracting properly. New belt was very straightforward to fit and works well

The retract mechanism broke on my existing driver’s seatbelt so I got one of these as a replacement. Fitted perfectly and works very securely.

Easy to install. On the passenger side i had to drill a hole in the bulkhead to mount the mechanism, otherwise the swivelseat could turn.

a good kit and fits my walkthrough late bay fine. as another review mentions, a spacer is needed on the B post so that the belt 'hanger' swivels properly but other than that a simple 17mm spanner job all round!

A sensible upgrade for really not much money which I highly recommend.

A couple of things to be aware of:

If you have a Type 2 Microbus with air vent duct running down the door cards into the rear of the bus, then you may well have to remove the 45 degree piece of plastic duct that is screwed to the bulkhead behind the seats to fit these belts properly. Fitting the reels above the vent duct is possible, but does not give such a secure anchor point.

I had to mess about with spacers (provided) on the top runner that the belt loops round & whichbolts to the B post to enable the runner to swivel as intended, allowing the belt to run out & retract correctly. I only had to do this on one side (the nearside) so may well not be a problem on other T2.

Overall though, an easy fit and a bit of a no-brainer at this price if your belts look remotely dodgy.

I put these seatbelts on my 72 crossover bay after a 4 year restoration and it really set off the cab area. They are well made and come with full instructions.

Quality made seatbelts by securon

Easy to install

Excellent value