Truma D6E Combi Heater (Diesel or Electric)

Quality Truma product. The Truma D 6 E is a powerful heating appliance which provides both hot air and hot water for you to use as required, within your RV. This advanced technology has a complex of engineering behind it, all packaged neatly within its smart looking exterior and user-friendly interface.

At a glance:

• Equipped with high quality burner for reliable heating while driving,

• Switch between diesel and electric mode depending on your location,

• Built with a 10-litre water tank, so you have the luxury of hot water on the go,

• User friendly operation involving digital CP plus iNet ready control panel,

• Create automatic climate control when used in combination with Truma air conditioner.

More about this super smart bit of kit...

What’s unique about the Combi 6 D E, is the 3 different operation choices.

You have the option to use the combi heater in:

• Diesel mode,

• Electric mode,

• Or combined diesel and electric mode.

The diesel only mode is designed for autonomous use, or in situations where access to an electric hook-up isn’t an option.

The electric only mode is for use with 230 V electric power supply, that could be from mains hook up at a campsite or elsewhere.

The combined diesel electric mode is where the magic happens.

This mode can only be used when the unit is producing both hot air and hot water. While in this mode, the Combi 6 D E automatically selects the operation method based on how much power is required. This purely depends on how radically the temperature must change before reaching the desired setting. The unit will choose either diesel or electric power, according to the difference between the temp set on the control panel and the room temp. If the boiler has already been filled, the water will automatically heat as well.

Measurements

The unit measures approximately 52.5 cm long, 45 cm wide and 30 cm high; surprisingly compact given the power of the appliance. Plenty small enough to fit within your vehicle in your allocated area, yet capable of heating your entire vehicle. The unit weighs about 16.9 kg, that’s without holding water.

Specifications and safety advice

It’s important that the unit is fitted by a certified gas engineer, relatively central to the space the unit will be heating. Service technicians must be able to easily access the unit, should removal or re-installation be required. This goes for installation of the exhaust tube as well.

Here's what’s included:

• Combi boiler, combi cover plate, breather tube, room temperature stat, holding down screws, installation & operating instructions,

• Water connection kit (including Frost control) Combi to Diesel Pump wiring loom, diesel pump and new flexible diesel pump holder

• Exhaust kit including, connection clip exhaust to combi, o ring for wall cowl, wall cowl (inc mounting screws and seal), 1m of exhaust pipe c/w sound muffler, cowl outer in black (inc mounting screws),

• iNet X control panel, 12v connection tail end, 6m data cable.

Electrical information

Output of 900 W (3.9 A) or 1800 W (7.8 A) can be manually preselected in electrical mode, in accordance with fuse protection at campsite.

Heat output in gas mode is rated to 3 different levels: 2000 W, 4000 W and 6000 W. Heat output in mixed mode is a maximum of 5800 W.

The combi has a fuel consumption of 220-630 ml/h with an average heat output of 1000 W. Power consumption at 12 V is 1.8 A maximum. Power consumption at 230 V is 3.9 / 7.8 A.

The unit has an air flow rate maximum of 287 m3/h.